Installation guide

NetVanta 6355 PoE Hardware Installation Guide Physical Description

SFP Module Slots

The NetVanta 6355 PoE supports two SFP slots that accept a number of industry standard SFP modules. The

SFP modules provide Gigabit Ethernet connectivity over fiber for high-speed uplinks or switch stacking. The

following modules are available for purchase (both of these modules require fiber optic cable with LC

connectors):

• 1200480E1 1000Base-SX Multi-Mode SFP Module

• 1200481E1 1000Base-LX Single-Mode SFP Module

Network Interface Modules Supported

The NetVanta 6355 PoE contains two NIM/VIM slots on the rear panel that support the following modules in

data applications:

• 1202862L1 T1/FT1 NIM

• 1202863L1 T1/FT1 + DSX-1 NIM

• 1200872L1 Dual T1 NIM

• 1200868E1 E1/FE1 NIM

• 1200878E1 E1/FE1 + G.703 NIM

• 1202869E1 ADSL NIM, Annex A

Voice Interface Modules Supported

The NetVanta 6355 PoE NIM/VIM slots on the rear panel support the following VIMs in voice applications:

• 1200690E1 Quad FXS VIM

• 1202691G1 Quad FXO VIM

• 1202692G1 Dual FXS/FXO VIM

• 1200695L1 T1/PRI VIM

• 1200696G1 E1/PRI VIM

Shipping Contents

Each NetVanta 6355 PoE unit is shipped in its own cardboard shipping carton. Open each carton carefully, and

avoid deep penetration into the carton with sharp objects.

After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit,

immediately file a claim with the carrier and contact ADTRAN Customer Service (refer to the Repair and

Replacement section of the Support page on the ADTRAN website at http://www.adtran.com/support).

Shipments of the NetVanta 6355 PoE include the following items:

• NetVanta 6355 PoE base unit

• Quick start guide

• A detachable power cable with a grounded, three-prong plug

• Mounting brackets and screws