System information

960 Stewart Drive Sunnyvale, CA 94085 USA Phone [phone] +1.877.80SHORE Fax [phone] www.ShoreTel.com
- 22 -
System Summary
Connect all of the appropriate cables (a T1 crossover cable between the ShoreGear T1 and the
NetVanta T1 interface and the appropriate Ethernet cables), then click on the “System Summary” link:
1. Verify that you don‟t have any warnings in the “System Information” section.
2. Verify that the “WAN Summary” section shows the T1 interface “Link” as “Up” and green.
3. Depending on your requirements – verify that Ethernet Interface 0/0 is disabled. (If you
wish to enable Ethernet 0/0 with a private IP address – you may do so. However, for
security reasons we prefer to have disabled the access to the internal LAN and have
disabled that interface).
4. Verify that the “Ethernet Summary” section shows the “Link” for both Ethernet interfaces
with the correct Ethernet link speed; and with 0/0 disabled and 0/1 enabled.
If you have any warnings, be sure to review your configuration and cabling.
Trunk Account Configuration
Click on the “Voice” link, this will expand the available options:
In the “Trunks” section click on “Trunk Accounts”, this action brings up the “Add / Modify / Delete Trunk
Accounts” page. You will need to add two separate trunk accounts (one for SIP and one for ISDN).
We‟ll add the SIP trunk account first:
1. Define a “Trunk Name:” that is appropriate, we chose EtherSpeak_SureTrunk
2. Set the “Type:” to “SIP”
3. Click on the “Add” radio button.
This action brings up the “Trunk Accounts > Txx” page which includes a “Trunk Status” section and “Edit
SIP Trunk” section. We‟ll begin with the “Trunk Status” section: