System information

960 Stewart Drive Sunnyvale, CA 94085 USA Phone [phone] +1.877.80SHORE Fax [phone] www.ShoreTel.com
- 14 -
determine which channel is being utilized), then click on the “Fill Down” radio button. This action will
automatically populate all of the remaining channels. Finally, be sure to “Save” all of the changes.
This completes all the configuration modifications necessary on the ShoreTel system.
Adtran Configuration
To get started with the ADTRAN device configuration, refer to the Quick Start Guide and ADTRAN
Operating System (AOS) and documentation CD included in the product box with each device. Quick
Start Guides may also be downloaded from the ADTRAN support Web site at www.adtran.com/support
by searching on the product device name. Once the ADTRAN device is unpacked and powered on,
ADTRAN NetVanta platforms can be configured via a command-line interface accessible from a com
port connect (9600 8 N 1) or via Telnet. Configuration may also be accomplished using the Web
interface GUI that provides step-by-step configuration guidelines.
Initial configuration will be via the CRAFT port, where you‟ll define an IP address on ETH 0/1, the
remaining configuration will be via the Web interface GUI. Plug your PC with a network cable and
DHCP enabled into either Ethernet port (0/0; 0/1). The default IP of the system is 10.10.10.1.
If using a Com Port
 Pre-configured for 9600 8 N 1 using a straight through dB 9, RS 232 cable.
 Username and Passwords are all set to adtran.
Once you have successfully logged in, perform the following actions:
CONFIGURE THE UNIT’S IP ADDRESS
1. At the # prompt, enter config terminal.
2. At the (config)# prompt, enter interface eth 0/1 to access the configuration parameters for the
ETH 0/1 Ethernet port located on the rear of the unit.
3. Enter ip address and assign an IP address to the Ethernet port using 24-bit subnet mask. This IP
address and subnet mask are only examples, configure an IP address and subnet mask that are
appropriate to your network environment. In addition, this IP address should be accessible from your
internal network so you can complete the configuration from the Web User Interface.
4. Enter no shutdown to activate the interface to pass data.
5. Enter exit to exit the interface commands and return to the Global configuration mode.
Depending on your configuration, you may need to set a default gateway as well as using the (config)#ip
default gateway command. If IP routing is enabled on the unit, do NOT set a default gateway.
Then enable Web interface access using the following configuration:
Web Access
Switch>
Switch>
Switch>en
Password:
Switch#conf t
Switch(config)#ip http server
Telnet configuration is not necessary but is recommended, use the following commands to enable
Telnet access:
Telnet Configuration
Switch>
Switch>
Switch>en
Password: adtran
Switch#conf t
Switch(config)#line telnet 0 4