Specifications

Total Access 600 Series System Manual Section 4.2 T1 TDM UIG

L2 PROTOCOL (T1[0] - AUTO)

View the status of the T1 interface with the L2 PROTOCOL set to AUTO (using Auto-config feature).

Reference DLP-014, Unit Installation Using the Auto-Config Feature for further details.

L2 PROTOCOL (T1[0] - AUTO) > STATUS

View the status of the auto detect function and traffic flow for the T1 interface with a L2 protocol set to

auto.

L2 PROTOCOL (T1[0] - AUTO) > STATUS > STATE

This field represents the state of the auto detect/configuration function. The possible states are:

L2 PROTOCOL (T1[0] - AUTO) > STATUS > TX PKTS

Number of packets transmitted out of the WAN port.

L2 PROTOCOL (T1[0] - AUTO) > STATUS > RX PKTS

Number of packets received on the WAN port.

L2 PROTOCOL (T1[0] - AUTO) > STATUS > TX BYTES

Number of bytes transmitted out of the WAN port.

L2 PROTOCOL (T1[0] - AUTO) > STATUS > RX BYTES

Number of bytes received out the WAN port.

L2 PROTOCOL (T1[0] - AUTO) > STATUS > CLEAR STATS

Selecting this activator will clear the statistics.

OFF

The T1 interface is down so the auto detect/configuration process is

currently idle.

DETECTING L2

ROTOCOL

The T1 interface is up and waiting for the first control/signaling packet.

CONFIRMING FR

The T1 interface is up and one FR signaling packet has been received.

CONFIRMED FR

The T1 interface is up and two FR signaling packets have been received. It

takes two consecutive control/signaling packets of the same type to confirm

the detected protocol.

CONFIRMING PPP

The T1 interface is up and one PPP control packet has been received.

CONFIRMED PPP

The T1 interface is up and two PPP control packets have been received. It

takes two consecutive control/signaling packets of the same type to confirm

the detected protocol.