Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual
98 © 2002 ADTRAN, Inc. 61200624L1-1A
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > STATE
The state of the virtual circuit:
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > TX FRAMES
Number of Frame Relay packets that have been transmitted via this DLCI.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > RX FRAMES
Number of Frame Relay packets that have been received via this DLCI.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > TX BYTES
Number of Frame Relay bytes that have been transmitted via this DLCI.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > RX BYTES
Number of Frame Relay bytes that have been received via this DLCI.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > DE COUNT
Number of packets received on this DLCI with the Discharge Eligible (DE) bit set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > CR COUNT
Number of packets received on this DLCI with the command response (CR) bit set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > BECN COUNT
Number of packets received on this DLCI with the Backward Explicit Congestion Notification (BECN) bit
set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > FECN COUNT
Number of packets received on this DLCI with the Forward Explicit Congestion Notification (FECN) bit
set.
L2 PROTOCOL (T1[0] - FRE) > STATUS > PVC'S > UNKNOWN FRAME RX
Number of frames that have been received that the unit does not know where to route.
INACTIVE
The circuit exists but has been deactivated by the Frame Relay
switch.
EXISTS
The circuit exists at this point and should be activated soon.
ACTIVE
The circuit is fully active.
OFF
The circuit has been turned off by the DLCI mapping active
selection.