Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > INTERFACE

Shows the user the physical and logical port associated with each DLCI. This is a read-only field.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > DLCI

The Data Link Connection Identifier (DLCI) number identifies the virtual circuit being configured.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > MODE

The mode identifies how the data will be forwarded. The choices are;

The default is

ROUTE IP.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > BECN TIMEOUT (MSEC)

This value is expressed in milliseconds and represents the amount of time the unit will stop transmitting

over a PVC which received a packet with the BECN bit set. Range is 50-5000 msec, the default is

SECONDS.

L2 PROTOCOL (T1[0] - FRE) > STATUS

View the L2 protocol status for the T1 interface using the Frame Relay protocol.

L2 PROTOCOL (T1[0] - FRE) > STATUS > PORT

View the Frame Relay statistics on the WAN port.

L2 PROTOCOL (T1[0] - FRE) > STATUS > PORT > PORT INDEX

Integer used for identifying DLCIs on an interface. A single DLCI will always be port index 0. Subsequent

DLCIs will have incrementing port indices.

L2 PROTOCOL (T1[0] - FRE) > STATUS > PORT > SIGNAL STATE

Displays “up” when the unit is communicating with the Frame Relay switch; otherwise displays “down”.

L2 PROTOCOL (T1[0] - FRE) > STATUS > PORT > TX FRAMES

Total frames transmitted out the WAN port.

L2 PROTOCOL (T1[0] - FRE) > STATUS > PORT > RX FRAMES

Total frames received on the WAN port.

ROUTE IP

All IP data for this DLCI will be routed

BRIDGE ALL

All data for this DLCI will be bridged

ROUTE IP/BRIDGE OTHER

All IP data will be routed. All other data will be bridged.