Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

Shows UP if PPP IP Control Protocol has negotiated successfully.

L2 PROTOCOL (T1[0] - PPP) > STATUS > UP TIME

Displays how long the PPP session has been connected.

L2 PROTOCOL (T1[0] - PPP) > STATUS > TX PKTS

Number of packets transmitted.

L2 PROTOCOL (T1[0] - PPP) > STATUS > RX PKTS

Number of packets received.

L2 PROTOCOL (T1[0] - PPP) > STATUS > TX BYTES

Number of bytes transmitted.

L2 PROTOCOL (T1[0] - PPP) > STATUS > RX BYTES

Number of bytes received.

L2 PROTOCOL (T1[0] - PPP) > STATUS > CLEAR STATS

Selecting this activator will clear the PPP stats.

L2 PROTOCOL (T1[0] - FRE)

Configure the L2 PROTOCOL parameters and view the status of the T1 interface using Frame Relay protocol

from this menu.

L2 PROTOCOL (T1[0] - FRE) > CONFIG

Configure the L2 PROTOCOL parameters for the T1 interface using the Frame Relay protocol.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > MAINTENANCE PROTOCOL

The Frame Relay maintenance protocol is used on the WAN port. The maintenance protocol is used to send

link status and virtual circuit information between Frame Relay switches and other devices (such as

routers) that communicate with them. Possible choices are as follows:

ANNEX D (ANSI)

This is ANSI standard ANSI T1.617-D and is the most commonly used in the

United States.

ANNEX A (Q933A)

This is the CCITT European standard, ITU-T Q.933-A.

LMI

This was developed by a vendor consortium and is also known as the

“Consortium” management interface specification. It is still used by some

carriers in the United States.