Specifications

Total Access 600 Series System Manual Section 4.2 T1 TDM UIG

L2 PROTOCOL (T1[0] - PPP) > CONFIG > AUTHENTICATION > RX USERNAME

(This option is not available when the RX METHOD is set to none.)

This is the username used to authenticate the PPP peer. You can enter up to 31 characters in this field.

Default is no entry in the

RX USERNAME field.

L2 PROTOCOL (T1[0] - PPP) > CONFIG > AUTHENTICATION > RX PASSWORD

(This option is not available when the RX METHOD is set to none.)

This is the password or secret that is used to authenticate the PPP peer. You can enter up to 30 characters in

this field. Default is no password.

L2 PROTOCOL (T1[0] - PPP) > CONFIG > PPP

Configure the PPP specific parameters such as MAX CONFIG, MAX TIMER, MAX FAILURE, and FORCE PEER IP

DDRESS from this menu.

L2 PROTOCOL (T1[0] - PPP) > CONFIG > PPP > MAX CONFIG

This value is the number of unanswered configuration-requests that should be transmitted before resetting

PPP negotiations. The possible values are

5, 10, 15 and 20 (default).

L2 PROTOCOL (T1[0] - PPP) > CONFIG > PPP > MAX TIMER (SEC)

This value is the number of seconds to wait between unanswered configuration-requests. The possible

values are

1 SEC, 2 SECS, 3 SECS (DEFAULT), 5 SECS and 10 SECS.

L2 PROTOCOL (T1[0] - PPP) > CONFIG > PPP > MAX FAILURE

Due to the nature of PPP, configuration options may not be agreed upon between two PPP peers. This

value is the number of configuration-naks that should occur before an option is configuration-rejected. The

possible values are

5 (DEFAULT), 10, 15 and 20.

L2 PROTOCOL (T1[0] - PPP) > CONFIG > PPP > FORCE PEER IP ADDRESS

This option forces the PPP to negotiate the IP address entered instead of allowing the other an address to be

assigned by the remote end.

L2 PROTOCOL (T1[0] - PPP) > STATUS

View the L2 PROTOCOL status for the T1 interface using the PPP protocol.

L2 PROTOCOL (T1[0] - PPP) > STATUS > LCP

Link Control Protocol. Reflects LCP layer active.

L2 PROTOCOL (T1[0] - PPP) > STATUS > BCP

Shows UP if PPP Bridge Control Protocol has negotiated successfully.

L2 PROTOCOL (T1[0] - PPP) > STATUS > IPCP