Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

L2 PROTOCOL

Use the L2 protocol menu to select the L2 protocol, configure the protocol specific parameters and view

the status as shown in Figure 6.

Figure 6. L2 Protocol Menu

L2 PROTOCOL (T1[0])

Configure the L2 protocol and view the status parameters from this menu.

L2 PROTOCOL (T1[0]) > PROTOCOL

Configure the L2 protocol mode. Choices are PPP, FRE, and AUTO. The default is AUTO. Selecting AUTO

enables the Auto-config feature. Reference DLP-014, Unit Installation Using the Auto-Config Feature, for

more information.

The 0 in T1[0] represents a physical port. The T1 physical port is always 0.