Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

INTERFACES (FXS) > CONFIG > TANDEM > RING BACK TONE

(This option is only available for the Total Access 612/616/624.)

Used to enable or disable the option of generating ring back tone towards the T-span. Default is

DISABLE.

INTERFACES (FXS) > CONFIG > TANDEM > ANSWER SUPERVISION

Causes the polarity of tip and ring to be reversed when the far-end answers. Can be enabled or disabled.

Default is

DISABLE.

INTERFACES (FXS) > CONFIG > TANDEM > DNIS OPTIONS

This parameter is used in conjunction with DNIS Delay. Choices are DISABLE, ENABLE, and ENABLE W/ NO

NSWER WINK. Default is DISABLE.

INTERFACES (FXS) > CONFIG > TANDEM > DNIS DELAY

Sets the amount of time the voice module waits after it receives a wink before forwarding a DNIS digit if

the

DNIS OPTION is set to Enable. Choices are 0.5 SEC, 1.0 SEC, 1.5 SEC, 2.0 SEC, 2.5 SEC, 3.0 SEC, and 5.0

SEC. Default is 3.0 SEC.

INTERFACES (FXS) > CONFIG > TANDEM > FWD DISC DELAY

In Tandem mode, FWD DISC DELAY defines the delay between the time the forward disconnect is received

and the actual battery removal/reversal. Choices are

250 MSEC, 500 MSEC, 750 MSEC, 1 SEC, and 2 SEC.

Default is 1 SEC.

INTERFACES (FXS) > CONFIG > TANDEM > FWD DISC BATTERY

In Tandem mode, selects whether battery is to be removed or reversed during forward disconnect. Choices

are

REMOVE and REVERSE. Default is REMOVE.

INTERFACES (FXS) > STATUS

Displays the status of the FXS signal bits.

INTERFACES (FXS) > STATUS > PORT

Displays the port number.

INTERFACES (FXS) > STATUS > TA SIG

This parameter displays the status of the Transmit A signal bit. The high/low status is indicated by a 0 or 1.

INTERFACES (FXS) > STATUS > TB SIG

This parameter displays the status of the Transmit B signal bit. The high/low status is indicated by a 0 or 1.

INTERFACES (FXS) > STATUS > RA SIG

This parameter displays the status of the Receive A signal bit. The high/low status is indicated by a 0 or 1.