Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

INTERFACES (V35[2]) > STATUS > DTR

View the status of the Data Terminal Read (DTR) lead. Possibilities are OFF and ON. This is a read only

field.

INTERFACES (FXS)

View the FXS interface status and configure the FXS parameters from this menu.

INTERFACES (FXS) > CONFIG

Configure the FXS mode, line impedance and Tandem parameters from this menu.

INTERFACES (FXS) > CONFIG > PORT

Indicates the port on which the FXS is installed.

INTERFACES (FXS) > CONFIG > MODE

Choices are given below. Default is LOOP START.

This mode needs to be set based on how the network is set up and how each port is being

used. Each port does not need to be set to the same mode.

LOOP START

Sets the port to use FXS loop start signaling on the T-span and loop start

supervision on the analog 2-wire interface.

GROUND START

Sets the port to use FXS ground start signaling on the T-span and ground

start supervision on the analog 2-wire interface.

TR08 SINGLE

Sets the port to use Single Party Channel Unit signaling on the T-span (as

defined by TR-TSY-000008) and loop start supervision on the analog 2-wire

interface.

TR08 UVG

Sets the port to use Universal Voice Grade signaling on the T-span (as

defined by TR-TSY-000008) and either loop start or ground start supervision

on the analog 2-wire interface.

DPO

Sets the port to use Dial Pulse signaling to originate dialed numbers.

TANDEM (E&M)

Sets the port to use E&M signaling on the T-span and either loop start or

ground start supervision on the analog 2-wire interface. See the Tandem

submenus for more information.