Specifications

Total Access 600 Series System Manual Section 4.2 T1 TDM UIG

INTERFACES (ETH[1]) > STATUS > DATA RATE

Displays the data rate present on the Ethernet interface. The possibilities are 10BASET, 100BASET, and

N/A. N/A indicates the AUTONEGOTIATION is set to ON and there is no Ethernet connection. This is read only

field.

INTERFACES (ETH[1]) > STATUS > DUPLEX TYPE

Displays the duplex type present on the Ethernet interface. The possibilities are FULL DUPLEX and HALF

UPLEX. This is a read only field.

INTERFACES (V35[2])

View the V.35 interface status and configure the V.35 parameters from this menu.

INTERFACES (V35[2]) > CONFIG

Configure the DTE leads from this menu.

INTERFACES (V35[2]) > CONFIG > CTS

Sets the control characteristic of the clear-to-send lead. Choices are NORMAL (follows RTS) or FORCE ON.

Default is

NORMAL.

INTERFACES (V35[2]) > CONFIG > DCD

Sets the control characteristic of the carrier detect lead. Choices are NORMAL (follows valid signal on the

network interface) or

FORCE ON. Default is NORMAL.

INTERFACES (V35[2]) > CONFIG > DSR

Sets the control characteristic of the data set ready lead. Choices are NORMAL (follows DTR) or FORCE ON.

Default is

NORMAL.

INTERFACES (V35[2]) > STATUS

View the status of the DTE leads from this menu.

INTERFACES (V35[2]) > STATUS > RTS

View the status of Request to Send (RTS) lead. Possibilities are OFF or ON. This is a read only field.

The 2 in V35[2] represents a physical port. The V.35 physical port is always 2.