Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

INTERFACES

Use the INTERFACES menu to view and configure parameters for the T1, ETHERNET, V.35, and FXS

interfaces as shown in figure 5.

Figure 5. Interfaces menus

INTERFACES (T1[0])

View the T1 interface status and configure T1 parameters from this menu.

INTERFACES (T1[0]) > CONFIG

Configures the various T1 parameters and enable/disable loopbacks from this menu.

INTERFACES (T1[0]) > CONFIG > TIMING MODE

Choices are NETWORK and INTERNAL. Select NETWORK when the unit will receive timing from the network.

Select

INTERNAL when the unit will generate the timing. Default is NETWORK.

The 0 in T1[0] represents a physical port. The T1 physical port is always 0.