Specifications

Section 3 Network Turnup Procedure Total Access 600 Series System Manual

• The Total Access 600 Series base unit (Total Access 604, Total Access 608, Total Access 612,

Total Access 616, Total Access 624). The units come with installed wallmount brackets.

4. GROUNDING INSTRUCTIONS

The following provides grounding instruction information from the Underwriters’ Laboratory UL 60950

Standard for Safety of Information Technology Equipment Including Electrical Business Equipment, with

revisions dated March 15, 2002.

AC Power

The attachment-plug receptacles in the vicinity of the product or system are all to be of a grounding type,

and the equipment grounding conductors serving these receptacles are to be connected to earth ground at

the service equipment.

DC Power (Optional Battery Backup)

The Total Access units are not DC powered. However, an optional DC battery backup system is available

for the Total Access 604/608 (P/N 1200641L1) and the Total Access 612/616/624 (P/N 1175044L1,

1175044L2, or 1175044L4).

A supplementary equipment grounding conductor shall be installed between the product or system and

ground that is in addition to the equipment grounding conductor in the power supply cord.

The supplementary equipment grounding conductor shall not be smaller in size than the ungrounded

branch-circuit supply conductors. The supplementary equipment grounding conductor shall be connected

to the product at the terminal provided, and shall be connected to ground in a manner that will retain the

ground connection when the product is unplugged from the receptacle. The connection to ground of the

supplementary equipment grounding conductor shall be in compliance with the rules for terminating

bonding jumpers at Part K or Article 250 of the National Electrical Code, ANSI/NFPA 70. Termination of

the supplementary equipment grounding conductor is permitted to be made to building steel, to a metal

electrical raceway system, or to any grounded item that is permanently and reliably connected to the

electrical service equipment ground.

The supplemental grounding conductor shall be connected to the equipment using a number 8 ring terminal

and should be fastened to the grounding lug provided on the rear panel of the equipment. The ring terminal

should be installed using the appropriate crimping tool (AMP P/N 59250 T-EAD Crimping Tool or

equivalent.)

5. SUPPLYING POWER TO THE UNIT

AC Powered Systems

The AC powered unit comes equipped with a detachable power cord with a 3-prong plug for connecting to

a grounded power receptacle. As shipped, the unit is set to factory default conditions. After installing the

chassis, the unit is ready for power-up. To power-up the unit, ensure that the unit is properly connected to

an appropriate power source.