Specifications

Total Access 600 Series System Manual Section 3 Network Turnup Procedure

1. INTRODUCTION

This section discusses the unit installation process.

2. TOOLS REQUIRED

The tools required for unit installation are:

• Screws (customer-provided for wallmount installation)

• Screwdriver (for wall or rackmount installation)

3. UNPACK AND INSPECT THE SYSTEM

Each unit is shipped in its own cardboard shipping carton. Open each carton carefully and avoid deep

penetration into the carton with sharp objects.

After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in

transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer

Service, Product Support Information, and Training in the front of this manual).

Contents of ADTRAN Shipment

Your ADTRAN shipment of the unit (regardless of product or software load -- ATM vs TDM) includes the

following items:

• Mounting Instructions (P/N 61200680L1-19B)

• CD (P/N 3253052@A)

• Cable Tie (P/N 3292032)

• Silver Satin Cable (P/N 3127004)

• Four Rubber Feet (P/N 3270BF003)

• Power Cord (P/N 3127009)

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

During installation, power should be the last connection made.

Electronic modules can be damaged by static electrical discharge. Before handling

modules, wear an antistatic discharge wrist strap to prevent damage to electrical

components. Place modules in antistatic packing material when transporting or storing.

When working on modules, always place them on an approved antistatic mat that is

electrically grounded.