Specifications

Section 5 DLP-015 Total Access 600 Series System Manual

Purchase of a T1 TDM 612/616/624 Unit with the EC/ADPCM Card Installed for Later

Upgrade to ATM

For customers who plan to operate a TDM application initially, but eventually upgrade to an ATM

application, a Total Access 612/616/624 unit may be purchased with the EC/ADPCM card installed

(P/N 4200612L2#TDM, 4200616L2#TDM, 4200642L2#TDM).

1. When the circuit is converted to ATM, the customer may obtain the latest VoATM firmware from the

ADTRAN website (http://www.ADTRAN.com). Select S

UPPORT>POST-SALES TECHNICAL

UPPORT>FIRMWARE UPDATES>612/616/624 ATM or contact Post-Sales Technical Support at 888-

4ADTRAN.

2. Upgrade the Total Access 612/616/624 with the latest VoATM firmware. Instructions for upgrading the

unit can be found in DLP-007 and DLP-008.

3. Factory default the Total Access 612/616/624 by one of the following methods:

•Select S

YSTEM UTILITY>TERMINAL MODE. At the > prompt, type fac. You will then see “Restore

Factory Defaults and Reset Unit? (press 'y').” Press the y key to confirm default. The unit then

resets.

• If connected to the CRAFT port, power reset the unit and then restore power to the unit while

holding down the F key. You will then be prompted to confirm the factory default.

4. In the ATM code, the upgrade was successful if the following two things occur:

•The S

YSTEM INFO>FIRMWARE REVISION field does not display Error.

• When you select the M

ODULES>MODULES menu, the EC/ADPCM appears in Slot 7 as shown in

the following screen.

5. Reconfigure the unit for the specific application.

Follow-up Procedures

Once this procedure is complete, return to the procedure which referred you to this DLP and continue with

the tasks indicated there.