Specifications

Section 5 DLP-015 Total Access 600 Series System Manual

DLP-015

Purchase of Upgrade Package from ADTRAN

The upgrade package may be purchased from ADTRAN. This package includes the EC/ADPCM

(P/N 1200613L1) and the ADTRAN installation and test. If this package is ordered, the customer must

send the Total Access TDM 612/616/624 unit back to ADTRAN. Once received, the EC/ADPCM module

is installed along with the latest VoATM firmware. The upgraded unit is then tested and returned to the

customer. Please call ADTRAN CAPs department at 800-9-ADTRAN extension 7722 for this service.

Purchase and Installation of the EC/ADPCM Module by the Customer

An EC/ADPCM module may be purchased separately and installed in the Total Access 612/616/624 T1

TDM unit by the customer.

1. Remove power from the Total Access 612/616/624.

2. Remove the screws from the back of the Total Access 612/616/624, and then remove the cover.

3. Install the EC/ADPCM Module in the Total Access 612/616/624 as shown in the following figure.

4. Remove the two screws from the motherboard, install the two standoffs, and insert the screws through

the top the EC/ADPCM board into the standoffs.

5. Replace the cover on the Total Access 612/616/624 and tighten the screws.

6. Restore power to the Total Access 612/616/624.

7. Obtain the latest VoATM firmware from the ADTRAN website (http://www.ADTRAN.com). Select

UPPORT>POST-SALES TECHNICAL SUPPORT>FIRMWARE UPDATES>612/616/624 ATM or contact Post-

Sales Technical Support at 888-4ADTRAN.

Perform Steps Below in the Order Listed

Network Card

FXS Card

EC/ADPCM Card

(Installed and secured)