Specifications

Section 5 DLP-012 Total Access 600 Series System Manual

DLP-012

Perform Steps Below in the Order Listed

1. Connect to the unit using the RJ-45 CRAFT interface.

If you are not already connected to the unit’s CRAFT interface (either with a

VT100 compatible terminal or with a PC running VT100 emulation software), follow the procedure in

DLP-001 Connecting the Terminal or PC to the CRAFT Port. Connecting to the

CRAFT interface

limits the config transfer procedure to XMODEM Only.

2. Login to the unit. (See DLP-002 Logging in to the System for details.)

3. Go to the S

YSTEM UTILITY menu and select CONFIGURATION TRANSFER menu; press <Enter>

4. Set the T

RANSFER METHOD menu to XMODEM.

5. Select L

OAD AND USE CONFIG to start the transfer. Enter Y to confirm the transfer and prepare the unit

for the transfer download.

When the unit is ready to receive the XMODEM configuration file, the menu screen will clear and

display XMODEM/CRC: Transmit CONFIG file now... If this does not appear, please review the

steps above for possible configuration errors.

6. From the terminal emulation software, begin the XMODEM transfer by using the appropriate command

sequence. For Windows HyperTerminal, select Transfer>Send File. Enter the filename (including path)

and select XMODEM as the transfer method. Configuration files should have a .cfg extension.

If necessary, refer to the terminal emulation software documentation for help.

Because XMODEM data is being transferred in-band through the menu interface, the VT100 menus of

the unit will be inoperable from the

CRAFT interface. You can cancel the update at any time within the

terminal emulation software. (Please consult the documentation provided by the terminal emulation

software to determine how to do this.)

7. After the config transfer is complete, the Config Transfer menu will be displayed.

Follow-up Procedures

Once this procedure is complete, return to the procedure which referred you to this DLP and continue with

the tasks indicated there.

The following message is displayed: “Warning: WAN link may be reset after transfer

complete!”