Specifications

61200624L1-1A © 2002 ADTRAN, Inc. 373
TELNETTING TO THE UNIT
Introduction
If the unit is part of a management cluster connected to the local network, you may use a PC connected to
the network to Telnet into the unit. This procedure details the steps which must be performed to Telnet into
the unit.
Prerequisite Procedures
Complete DLP-004 and DLP-005 (steps 1 and 2 only).
Tools and Materials Required
• Access to a PC or other computer connected to the LAN.
• VT100 compatible terminal or computer with terminal emulation software
• Appropriate cable to connect terminal to the unit (customer-provided)
• DB-9 female to RJ-45 female adapter (customer-provided) for connecting to the
CRAFT port on the rear
of the unit. This adapter is ADTRAN-proprietary.
• Ethernet cable from
10/100BASET port on the unit to a hub (customer-provided)
• Use Ethernet crossover if going from the unit to a PC (customer-provided).
In this DLP, unit refers to the Total Access 604, 608, 612, 616, and 624.
The ATM D.01.XX firmware supports one telnet session active at a time. The TDM
A.03.XX firmware supports on telnet session active at a time. The TDM A.04 firmware
supports five simultaneous telnet sessions.