Specifications

SETTING ETHERNET IP PARAMETERS

Introduction

If the unit is connected to an IP network for Telnet, TFTP, or SNMP management, several IP parameters

must be set for the unit to communicate with the network. These parameters are described in this DLP

along with the procedures for setting them.

Prerequisite Procedures

This procedure assumes that the unit is connected to an IP network and is powered up.

Tools and Materials Required

• VT100 compatible terminal or computer with terminal emulation software

• Appropriate cable to connect terminal to the unit (customer-provided)

• DB-9 female to RJ-45 female adapter (customer-provided) for connecting to the

CRAFT port on the rear

of the unit. This adapter is ADTRAN-proprietary.

• Ethernet cable from the

10/100BASET port on the unit to a hub (customer-provided)

• Use Ethernet crossover if going from the unit to a PC (customer-provided).

Please see your Network Administrator for the proper assignment of the following

parameters:

IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

In this DLP, unit refers to the Total Access 604, 608, 612, 616, and 624.