Specifications

Section 4.6 SHDSL ATM UIG Total Access 600 Series System Manual

Managing the Modules – Modules

Use the MODULES menu to view and set the parameters shown in Figure 17. The Total Access 600

contains four fixed modules: The WAN/Network interface, FXS, Echo Canceller/ADPCM module, and the

V.35 interface. The M

ODULES table allows management of the on-board modules in the Total Access 600.

This menu contains M

ENU, ALARM, TEST, and STATUS indicators/menus customized for each module.

Figure 17. Modules Menu

>NET (SHDSL)

Data Rate

Used to select data rate of the network connection. (This should match the DSLAM settings.)

Frame Mode

Used to select either SDSL Framed (def) or SDSL Framed Plesiosynchronous with bit stuffing. (This

should match the DSLAM settings.)

Annex A/B

Used to select ANNEX A, ANNEX B, or both.

ITU-991.2/Gspan

Chooses between ITU-T 991.2 or GLOBESPAN V1.2.

Test

These tests are meant for debug purposes only. A reboot may be required to return the Total Access 600 to

normal operation.

Network Loopback

Sets the network interface in loopback mode.