Specifications

Section 4.5 SDSL ATM UIG Total Access 600 Series System Manual
264 © 2002 ADTRAN, Inc. 61200624L1-1A
%Loss
Percentage loss based on ping returned from host (read only).
Configuring WAN Settings
>DSLAM Type
Set this to the type of DSLAM the Total Access 600 will be connecting to.
>Layer One Interface
This is the physical layer protocol used to connect the DSLAM to the Total Access 600.
>Layer Two Protocol
This is the data link layer protocol used to connect the DSLAM to the Total Access 600.
>ATM Config
Use the W
AN menu (Figure 6) to access the ATM CONFIG menu.
Figure 6. WAN Menu
Use the ATM CONFIG menu (Figure 7) to set the parameters listed below the figure.
If the DSLAM Type is CopperMountain, refer to Appendix E. Routing in HDIA Mode for
further information.