Specifications

Section 4.5 SDSL ATM UIG Total Access 600 Series System Manual

Start Transfer

This activator is used when the configurable items in this menu are complete.

Abort Transfer

Use this activator to cancel any TFTP transfer in progress.

>Config Transfer

Sends a file containing the Total Access 600 configuration to a PC connected to the CRAFT port using

XMODEM protocol or to a file on a TFTP server using the TFTP protocol. See DLP-007, Upgrading the

Firmware Using XMODEM and DLP-008, Upgrading the Firmware Using TFTP for details.

ONFIG TRANSFER also lets you save the Total Access 600 configuration as a backup file, so you can use

the same configuration with multiple Total Access 600 units. In addition, C

ONFIG TRANSFER can retrieve

a configuration file from a TFTP server.

To support these transfers, ADTRAN delivers a TFTP program with the Total Access 600 called

TFTP Server. You can configure any PC running Microsoft Windows with this software, and store a

configuration file.

Only one configuration transfer session (upload or download) can be active at a time.

Transfer Method

Displays the method used to transfer the configuration file to or from a server. XMODEM and TFTP are

supported.

Transfer Type

Only BINARY transfers are currently supported.

TFTP Server IP Address

Specifies the IP address of the TFTP server. Get this number from your system administrator.

TFTP Server Filename

Defines the name of the configuration file that you transfer to or retrieve from the TFTP server. The default

name is

ta600.cfg, but you can edit this name.

Before using START TRANSFER, the Total Access 600 should have a valid IP address,

subnet mask, and default gateway (if required).

Before using CONFIG TRANSFER, the Total Access 600 should have a valid IP address,

subnet mask, and default gateway (if required).