Specifications

Total Access 600 Series System Manual Section 4.4 ADSL ATM UIG
61200624L1-1A © 2002 ADTRAN, Inc. 217
Use the ATM CONFIG menu (Figure 28) to set the parameters listed below the figure.
Figure 28. ATM Config Menu
Idle Cells
The IDLE CELLS format must be configured for either ATM FORUM or ITU. Configuring this setting incor-
rectly for a particular circuit will cause poor performance at the ATM layer.
Data Scrambling
D
ATA SCRAMBLING can be ENABLED or DISABLED for cell traffic. Configuring this setting incorrectly for a
particular circuit will cause poor performance.
>ATM Stats
Use the W
AN menu (Figure 27 on page 216) to access the ATM STATS menu (Figure 29 on page 218) and
view the parameters listed below the figure.
This setting must match the configuration setting of the ATM switch or DSLAM at the other
end of the circuit.
This setting must match the configuration setting of the ATM switch or DSLAM at the other
end of the circuit.