Specifications

Total Access 600 Series System Manual Section 4.3 T1 ATM UIG
61200624L1-1A © 2002 ADTRAN, Inc. 193
Appendix B. RFC1483 Quick Start (IP Routing)
The Total Access 600 allows for complete integration of voice and data delivery from one compact
platform (see Figure 20). Once you have completed the voice turn up procedure from the previous
example, adding data to the circuit requires some additional setup.
Figure 20. Application Diagram
To configure a Total Access 600 for IP routing, you need to know the VPI and VCI values for the data
circuit on your network. You also need the IP address of the next hop router in the circuit.
The table on the next page shows how to configure the Total Access 600 for IP Routing.
.
IP Routing
Step Action
1.
From the Total Access 600 main menu, select the WAN menu. (Here
you set up the ATM network.)
2.
Select the ATM CONFIG menu.
3.
Enter the IDLE CELLS format for your network.
4.
Set DATA SCRAMBLING appropriately for your network.
5.
Back all the way out to the top level Total Access 600 menu, and then
select the R
OUTER menu.
TX
R
X
LINK
V.35 RX
V
.3
5
T
X
D
A
T
A
V
O
IC
E
B
A
T
T
P
W
R
/
N
E
T