Specifications

Section 4.3 T1 ATM UIG Total Access 600 Series System Manual
190 © 2002 ADTRAN, Inc. 61200624L1-1A
The following settings are used for FRF8.
LAN FR MAINT PROTOCOL
Frame Relay maintenance or signaling
protocol between local V.35 port and the
attached DTE port, support ANSI Annex A,
CCITT Q933 Annex D, CISCO LMI or
Static (no signaling).
LAN FR POLL TIMEOUT
T392 (5-30)
T392 for signaling protocol, typical value
15. No meaning if Maint Protocol is Static.
FR/ATM PVC MAPPING
Up to 4 mappings are supported.
FR DLCI
Frame Relay DLCI on V.35 port.
ATM VPI
Specifies the virtual path to which DLCI is
mapped.
ATM VCI
Specifies the virtual circuit to which DLCI is
mapped.
TRANSLATE
Translate or transparent mode between
Frame Relay frames and ATM cells.
DE MAP
Map Frame Relay DE bit to ATM CLPI bit,
Always 0, Always 1 or Convert each other.
FECN MAP
Map Frame Relay FECN bit to ATM EFCI
bit, Always 0, Always 1 or Convert each
other.