Specifications

Total Access 600 Series System Manual Section 4.3 T1 ATM UIG

Configuring Voice Support – Config

Use the VOICE/CONFIG menu to view and set the parameters shown in Figure 15.

Figure 15. Voice/Config Menu

>Call Control

The C

ALL CONTROL setting is used to configure the correct Voice Gateway protocol for voice signaling

control between the Total Access 600 and the configured Gateway. The C

ALL CONTROL setting must be

configured correctly before the voice circuits will work correctly. The Total Access 600 supports

Jetstream, Tollbridge, and CopperCom Voice Gateways.

>VPI

The VPI setting is used to configure the Total Access 600 virtual path setting used to communicate with the

configured Voice Gateway.

>VCI

The VCI setting is used to configure the Total Access 600 virtual circuit setting used to communicate with

the configured Voice Gateway.