Specifications

Section 4.2 T1 TDM UIG Total Access 600 Series System Manual

L2 PROTOCOL (ETH[1])

Configure the L2 PROTOCOL parameters and view the status of the Ethernet interface from this menu.

L2 PROTOCOL (ETH[1]) > PROTOCOL

Displays the L2 protocol for the 10/100BASET Ethernet port. Currently only 802.3 is supported.

L2 PROTOCOL (ETH[1]) > CONFIG

Configure the mode for this 10/100BASET Ethernet port from this menu.

L2 PROTOCOL (ETH[1]) > CONFIG > MODE

The mode identifies how the data will be forwarded. The choices are;

The default is

ROUTE IP.

L2 PROTOCOL (ETH[1]) > STATUS

View the L2 protocol statistics for the 10/100BaseT Ethernet port from this menu.

L2 PROTOCOL (ETH[1]) > STATUS > TX PACKETS

Total number of packets transmitted out the Ethernet port.

L2 PROTOCOL (ETH[1]) > STATUS > RX PACKETS

Total number of packets received from the Ethernet port.

L2 PROTOCOL (ETH[1]) > STATUS > TX ERRORS

Total number of transmit errors encountered on Ethernet port.

L2 PROTOCOL (ETH[1]) > STATUS > SINGLE COLLISIONS

Total number of single collisions before successful transmission.

The 1 in ETH[1] represents a physical port. The Ethernet physical port is always 1.

ROUTE IP

All IP data will be routed

BRIDGE ALL

All data will be bridged

ROUTE IP/BRIDGE OTHER

All IP data will be routed. All other data will be bridged.