User manual

TSU ACE User Manual Chapter 3 Operation
61202295L1-1A © 2003 ADTRAN, Inc. 27
Figure 3-3. TSU ACE Main Menus
Status
Use the S
TATUS
menu to view the operational status of the TSU ACE. (Also see Status Menu on page 33.)
This menu includes the following submenus:
Config (Configuration)
Use the C
ONFIGURATION
menu to set the TSU ACE operational configuration. (Also see Config Menu on
page 37.) This menu includes the following submenus:
1) NI PERF REPORTS
1) STATUS 2) CURR ERR/ALM
3) ERR/ALM HIST
1) NETWORK (NI)
TSU ACE Main Menus 2) CONFIG 2) PORT
1) SOFTWARE REV
3) UTIL 2) REINIT UNIT
3) ADDRESS
1) NETWORK TESTS 4) SET PASSCODE
4) TEST 2) RUN SELFTEST 5) KEYPAD
3) PORT TESTS 6) FACT RESTORE
NI PERF RPTS
Use to view and reset the user set of data on the Network Interface Performance
Reports. These reports are in compliance with ANSI T1.403 and AT&T document
TR54016.
CURR ERR/ALM
Use to view current errors and alarms as reported by the TSU ACE.
ERR/ALM HIST
Use to view and clear the history of errors and alarms.
NETWORK (NI)
Use to set all of the parameters associated with the network interface.
PORT
Use to configure the parameters associated with the DTE (V.35) port.