User manual

Chapter 5. Configuration Menu
61202156L1-1 TDU 120e User Manual 5-15
Review Map A(B)
Permits a quick review of the number of DS0s assigned to
each port and the number of unassigned DS0s (IDLE or TST)
as defined in the currently applied Map A(B).
Review Temp Map
This menu item is operated the same as R
EVIEW
M
AP
A (B).
Edit Temp Map
The map in the TEMP file can be edited to whatever configu-
ration is desired. If Map A had been copied into the TEMP
file, then after editing, the TEMP file could be applied to Map
A or Map B.
Apply Temp to Map A(B)
Writes the TEMP map into Map A (B). Apply is usually the
last step in updating a map.
Port Configuration (Port Config)
P
ORT
C
ONFIGURATION
is used to select and configure the
parameters associated with any data port in the unit. For
example, parameters for the DS-1 (PBX) interface are set
through this menu. The items that can be set depend on
which option module is installed. The list of option ports will
vary with the configuration.
The TDU 120e is designed so that any additional ports
developed in the future will contain the appropriate menu
selections to provide access by use of this menu item.
The Configuration menus for options ports are described in
separate sections of the manual supplied with the option
card.
Nx/DBU (0.1) Menu Items
Nx/DBU (0.1)
The Nx/DBU port has two main menus:
Nx56/64 config -- Nx operation