User manual

Chapter 5. Configuration Menu
61202156L1-1 TDU 120e User Manual 5-13
Editing the Temp Map
If further changes to the Temp map are needed, do the
following:
Applying the Temp Map
Once the Temp map reflects the desired configuration, use
selections 8 or 9 to apply this configuration to Map A or B,
respectively.
Step Action Explanation
1
Use selection 7 to enter the
Temp map edit mode.
Upon entering this mode, the cursor
location moves to DS0 number one in
the DS0 field of the Temp map.
2
Move the cursor from one
DS0 to another by using
the up and down arrows.
Locate the DS0 number whose
assigned port needs to be changed.
3
Press
Enter.
The cursor will move into the Port field.
4
Use the up and down
arrows or space bar to
scroll through the possible
port selections.
To restore the previous port assign-
ment and return to the DS0 field, press
ESC
.
To save the current selected port and
return to the DS0 field, press
Enter
.
When the cursor is again located in the
Temp map DS0 field, press
ESC
a sec-
ond time. This causes the cursor to
return to selection 1 below the Temp
map display.