User manual

Chapter 3. Operation
61200105L3-1A E&M+ Dual Voice Option ModuleUser Manual 3-7
Port Utility (PORT UTIL)
PORT UTILITY, a submenu of the TSU 100/120/600 menu UTILITIES
(UTIL) displays the current software information for each port
installed in the unit. This information is required when requesting
assistance from ADTRAN Customer Service or when updates are
needed. When P
ORT UTILITY displays, place the cursor over it and
press
Enter to display the first available port (see Figure 3-6).
Figure 3-6. Port Utility Submenus
Go to 1.1 E&M+ (scroll to display if necessary), and press
Enter.
The TSU displays the option module name and the software version
installed. Although P
ORT UTILITY contains a second option for the
E&M+ voice module, CMD M
ODE, this menu is reserved for
factory use only. To exit the menu or to select another port, press
C
ANCEL.
Port Test
PORT TEST, a submenu of the TSU 100/120/600 menu TEST,
activates tests on selected data ports. Select E&M+ to display tests
available for the E&M+ voice module (see Figure 3-7 and
Table 3-2 on page 3-8). When P
ORT TEST displays, place the
cursor over it and press
Enter to display the first available port.
Scroll to select 1.1 E&M+ and press
Enter to activate the following
menus:
• 1 KHZ TONE
• VIEW SIG BITS
• SET TX SIGNAL
• SET E-LEAD
• LOOPBACK
1) TIME/DATE
2) FACTORY RESTORE
3) UTIL 3) SET PASSCODE
4) UNIT ID 1) SW REVISION
5) PORT UTILITY 1.1 E&M 2) CMD MODE
6) SOFTWARE REV