User manual
ADT-HC4500 CNC Flame/Plasma Controller
78
2. In case of similar Chinese with two Bytes a word, please name it as config2.ini,
In case of similar English with one Byte a letter, please name it as config3.INI
3. Translate the content behind “=” in new file to Chinese, while other contents do not change.
4. For any question, please compare the English configuration file of config1 with the Chinese
one in folder ADT.
Note:
1. Character ';’ acting as the ending mark of configuration value, can be followed by remark.
2. It is not allowed to have sign '=' in remark and the value of configuration parameter.
3. It is not allowed to change the sequence of parameter in every interface, and do not use '[]';
4. To add new parameter, please add at the end of the interface;
5. When translating, due to the small controller screen, the number of character should be
strictly controlled for the parameters;
6. The content in '[]' should not be translated;
7. If it is blank behind the equal sign, it is to reserve a space for the previous line, which means
that it can write the exceeding part of translation of the previous line.
For example: (Chinese)
1.[开机界面]
[1] =深圳众为兴数控技术有限公司;(≤60 Byte)
[2]=;
[3] = …;
Translation:
1. [Starting interface]
[1]=ADTECH CNC TECHNOLOGY;
[2]= CO., LTD (SHENZHEN);
[3] = …;
5. If there is any doubt, Please refer to translation docomet or contact suppler.