User manual

ADT-HC4500 CNC Flame/Plasma Controller
68
Picture 6.2.4 Interface of setting factory default verification
After entering the correct password in interface as above, the following interface will show up:
Picture 6.2.5 Interface of setting factory default prompt
In this interface, press [ENTER] and the system will set the parameters set in “Parameter” options to
factory default. After each “restoration”, the parameters will be restored to the previous stored factory default.
Once the settings are saved, the system will show a prompt interface as Picture 6.2.6. If you do not want to
set the current settings as factory default, you can press [ESC] to cancel and press [
] or [ ] to exit.