User manual
ADT-HC4500 CNC Flame/Plasma Controller
66
[F2]: Connect the USB disk
[F3]: Reserved, not in use for the moment
[F4]: Restart the control system
[F5]: Connect the computer
[F6]: Main help system
[INS]: Enable the help system of current interface
6.2 Restoration (Rev)
In upgrade interface as Picture 6.1, you can press [F1] to enter the system parameter
restoration/storage interface.
Picture 6.2.1 System parameter restoration/storage interface
In this interface, the system asks users to restore or to set factory default. To restore, press [F1]. After that,
the system will give a prompt showing the system is restored, as picture 6.2.3. If you press [F1], the system
will enter the interface prompting the factory default, as Picture 6.2.4; otherwise, press [ESC] to return to the
previous interface.
Note: If the system parameters have never been saved, the parameters will be messed after the
restoration. In this situation, it is not allowed to be restored. The operating interface is as Picture 6.2.2.