User manual
ADT-HC4500 CNC Flame/Plasma Controller
56
4.1. 2 Flame Step Torch Height
Press 【F4】flame in the config parameter setting interface, enter flame step torch height parater
setting interface: press figure input parameter value, Press 【Y+】【Y- 】select parameter.
Picture 4.1.2 Flame step Torch Height
Parameters Details:
1) Z axis Torch height allow: When Status “Open”, Flame cutting of system can accept Z axis make the
gun make adjustment of height
2) Z axis pulse equivalent: Z Axis setting of precision, See 4.5.1 (Pulse equivalent Setting)
3) Z Axis initial speed: See 4.2.1 (speed setting)
4) Z axis acceleration: See 4.2.1 (speed setting)
5) Z axis end speed: See 4.2.1 (speed setting)
6) Gun up-down speed: Distance of first time down to preheat height (Disstance of gun from cutting safe
height up to initial height)
7)Cross hole up-down distance: the distance from cutting height up to safe height (Distance of Gun from
safe height down to cutting height), to avoide the schmelze enter into gun nozzle when high temperature
After related parameter input finished, press 【F6】for save.
4.2 Speed
In system parameter setting interface as Picture 4, press [F2] and the interface will become as the following