User manual

ADT-HC4500 CNC Flame/Plasma Controller
50
c Arcing, arcing delay M12
d Perforating, perforating delay
Start the following actions
Users can define the functions of M07 as required.
4) [F2] is used to define the M08 instruction. The system default M08 instruction for closing cutting
oxygen is as follows:
Flame:
c Cutting oxygen off, M13
d Cutting gun rising (Fixed Cycle), M70
Plasma:
c Close striking arc M13
d Close the height-adjusting control M23
Users can define M08 to M80 (close all output) according to their actual demand. All valves will
be closed when performing M08 to save gas.
5) [F3]: Clear the data of current line.
6) [F4]: Add a new line below the current line.
7) [F5]: Delete the current line.
8) [F6]: Save the content.
9) [INS]: Open the help system of the current interface
Note: After you have defined M07 and M08 instructions, you should set [F1] (Configuration) in [F4]
(Parameter) as “user-defined”; otherwise, the instructions would not be effective.
3.2 Editing processing file
As shown in Picture 3.1 at the beginning of this section, in the interface of editing, if you create a new file
or load a file, and enter the edition interface, you can then edit the processing file as follows: