User manual
ADT-HC4500 CNC Flame/Plasma Controller
39
Direct change coordinate refers to that the cutting gun does not move but the coordinate is changed to
the coordinate of perforating point directly.
Auto move gun refers to that the cutting gun is moved from current position to perforating point.
After that, select any M07 perforating point during the figure processing to process, and input
the perforating point and press [ENTER]. To make fine adjustment, you can press [X+] or [X-] to select
the next perforating point.
1.2.5.1.8 Array
See “Array” in section 16 of Chapter II.
1.2.5.1.9 Restoration (Rev)
In processing interface as Picture 3.1.2.5.1, press [F6] (Rev) to restore the figure after the array,
point/line selection to the shape when loading.
Note: In rotation interface, it can only restore the figure to the state before rotating
Only in processing interface can the figure after the array operation be restored.
1.2.6 Back to origin
In auto interface, press [F5] and the cutting gun will return to origin at the current manual speed.
When in auto running, it’s required to press [Stop] to allow system to be stable before pressing [F5].
1.2.7 Breakpoint (Spot)
Functions of breakpoint:
1) Find the coordinate before power down when the power supply is resumed.
2) Set a breakpoint memory on the current track for changing the cutting nozzle.
3) Set a breakpoint memory on the current track for displacement perforating.