User manual

ADT-HC4500 CNC Flame/Plasma Controller
35
Picture 3.1.2.2.1 Inching setting interface
If “Inching” is not highlighted, it is default that once [X+], [X-], [Y+], or [Y-] is released, all axes
are doing continuous motion until these keys are pressed again or the [Stop] key is pressed when the
system will decrease and stop moving.
If you press [G] key, the system will be switched between manual and inching. If in inching state,
keep holding [X+], [X-], [Y+], or [Y-] and the related axis will perform the continuous motion until
they are released when the system will decrease and stop moving.
1.2.2.2 Breakpoint