User manual
ADT-HC4500 CNC Flame/Plasma Controller
33
cycle, and then runs the processing program.
[2]. the controller travels back to where the processing program pauses, and then stops.
[3]. the controller enables the cutting at current position, and then returns to where the
processing program pauses and runs the processing program. The three options can be selected
by pressing [Y+] or [Y-] to move “←” up and down. After that, press [ENTER] to run the
relevant function.
[4]. Proceed running the program code at offset position, and does not return to where the
track is located when paused.
Press [ESC] to cancel, and wait at the current position for the users to decide whether to
continue processing.
3) Perforating instruction will be performed automatically according to the program status.
You can press pause to stop the M07 instruction.
1.2 Details of submenu in auto interface
1.2.1 Travel
(Auto)→ [F1] (Travel): the system only runs X, and Y tracks, and the switches of preheating
oxygen, acetylene, cutting oxygen, arcing, and cornering are not opened. It is for calculating whether the track
and the size of running steel plate are correct.
(Auto) →【Y】, testing plate function. System will run automation an idling process picture of
min rectangle figure
Travel and TEST speed is the maximum manual speed, and is not controlled by the speed
percentage.
1.2.2 Manual
In main menu → [F1] (Auto) → [F2] (Manual) to enter the manual interface: