User manual

ADT-HC4500 CNC Flame/Plasma Controller
29
Press [X+] [Y+], or [Y+] [X+], then, press [ENTER] to confirm. The position of
figure to be processed and the steel plate is shown as follows:
20Tool Setting
Main Interface after power on, pressF1Auto---F4Graph, Enter into Graph track follow
interface, Press key G.
Graph Original start point will turn to position of lower left quarter, Press Key G, The
graph start point will positioned 5 directions like original point, lower left quarter, Lower Right
Corner, top right corner, top left corner.
Picture 2.20
Positioning process Set start to lower right corner
The program will restore automationly when used this fuction.
When you press key ofStartfor processing, cutting gun will start move from “select start” to
program original point, then make the processing