User manual
ADT-HC4500 CNC Flame/Plasma Controller
28
Way of calibrating the steel plate:
1) As above picture, point A is the start point of cutting gun. You can figure out the slope angle of
the steel plate by moving the cutting gun to any point of its base line. Press [X+] → [Y-], or [Y-]
→ [X+]; then, press [ENTER] to confirm.
2) Then, the figure displayed on the controller will be rotated at a certain degree. The position of
figure to be processed and the steel plate is shown as follows:
3) If the steel plate is inclined as follows, then, the calibration method is as below:
Original position
Position after the move
Original position
Position after the move