User manual
ADT-HC4500 CNC Flame/Plasma Controller
27
and the X axis of reference coordinate.
Reference axis Y: the offset angle of steel plate is the angle formed by Y axis of steel plate and
the Y axis of reference coordinate.
Press 【X+】【X-】【Y+】【Y- 】to select the move cutting gun, at the same time, the system will
calculate the angel automationly.
The following calibration takes X axis as the reference axis.
The principle of calibration taking X axis as reference axis is as follows:
Picture 1 Picture 2
1) In Picture 1, the large frame (Real line) is the steel plate, the small frame (Dashed line) is the
figure to be cut, and point A is the start point of the cutting gun. If it is cut according to Picture 1,
the figure outside may not be cut; and if it is cut when the start point is moved to the middle of
the steel plate as Picture 2, obviously it will waste the steel plate.
2) At this point, without moving the steel plate, you just have to figure out the slope angle of the
plate, and incline the figure to be processed at the corresponding angle before cutting effectively.
A