User manual

ADT-HC4500 CNC Flame/Plasma Controller
20
2.12 Change of cutting gun nozzle
FBack and Cutting : Go back to the
interrupt with no cut then cut continue the program.
FBack and Stop : Go back to the
interrupt with no cut then stop program..
CBack and Cutting : Go back to the
interrupt with cutting then then cut continue program.
Process ringht here : cut continue program right here.
13. Displacement perforating
Picture 1 Picture 2
As picture 1, the outer is square steel plate and the inside rectangle is the workpiece to be cut. Assuming
that it is to cut the work piece from point A and the steel plate is of thick materials; then, it will cost a lot of
time to perforate. However, if it is to cut from the edge of steel plate (point B), the time of preheating
perforating may be saved. Detailed operations are as follows:
c In automatic processing d Press [STOP] e Press the corresponding X, and Y keys to move the
cutting gun to the edge of the steel plate f Press [Start] again g Select the relevant item in the popped up
dialogue box h Press [ENTER], the coordinate will be moved to the current break point automatically and
proceed the processing of selected item.
B
B
A