User manual
ADT-HC4500 CNC Flame/Plasma Controller
18
2.9.1 Control interface
In auto cutting interface, it will carry out preheating before perforating. Total preheating time and the
current preheating time will be shown on the right bottom of the interface; on the left bottom there will show
“Record & GO, Press [G]; Stop, press [START]; Go-on, Press [STOP].” As prompted, if you press
[START], the system will stop preheating immediately and go to the next action without saving the preheating
time. If you press [STOP], the preheating time will be extended without limit. Press [G] to stop preheating, and
the system will save the “Current preheating time” automatically as the “Preheating time” for the future.
In main menu, press [F1] (Auto):
2.9.2 Preheating in auto interface