User manual
ADT-HC4500 CNC Flame/Plasma Controller
102
3) However, though the impulse equivalent value is adjusted as precise as 0.001000, the processing
speed of the system will be slowed down. Therefore, too small an impulse equivalent value is not
recommended.
4.2 Current adjustment of driver
Please adjust the current following the driver instructions of different factories. If you use equipped
stepping driver Q2BYG404MA+56BYGH630C of ADTECH, please adjust the current of driver to be 1.2 times
of motor current.
4.3 Test method of impulse equivalent
Please see Chapter II— Quick Start — 1 Parameter Settings— 1.5 Precision Settings (Page 18) in
this user manual.
4.4 Anti-interference measures
Follow the following steps to carry out the anti-interference measures:
1) PE input port (Ground terminal) of NCS 24V power supply should be connected to the ground.
Connect the ground wire
of the shell