User manual
ADT-TP3340DJ Three-axis Dispenser
- 8 -
3) Pulse equivalent setting wizard
(Step I)
(Step II)
(Step III)
(Step IV)
Pulse equivalent setting wizard
Please make sure that you have read the user manual of this system and connect the
wires according to the wiring diagram. If the motor uses step drive, you need to set the
freewheeling and drive current of the drive. If it is servo drive, you need to understand
the basic condition of servo, such as encoder wires and electronic gear ratio of the servo.
Finally, please make sure that the motor is in an open position, and prepare a vernier
caliper. This wizard completes pulse equivalent setting by measuring certain length of
motor movement.
Next Exit
Pulse equivalent setting wizard
Please select the axis (or axes) to complete pulse equivalent
setting through wizard.
X-axis Y-axis Z-axis
Previous Next Exit
Pulse equivalent setting wizard
Please move the motor to the first position (any position), and make sure
that the motor speed won’t cause the motor out of step.
X forward rotation/ X reverse rotation/ Speed:
Y forward rotation/ Y reverse rotation/ Speed:
Z forward rotation/ Z reverse rotation/ Speed:
Previous Next Exit
Pulse equivalent setting wizard
Please move the motor to the second position (keep far away from the
first position). Make sure that the motor won’t bump the limit.
X forward rotation/ X reverse rotation/ Speed:
Y forward rotation/ Y reverse rotation/ Speed:
Z forward rotation/ Z reverse rotation/ Speed:
Previous Next Exit