User manual

ADT-TP3340DJ Three-axis Dispenser
- 37 -
Now, the BootLoader program is started.
Note:
1. Do not hold the “ESC” key for too long time. When the above info appears, press the key
once.
2. If the above info doesn’t appear, please check whether the serial port setting is proper and
whether the serial port wire connection is proper.
3. If the program is already started, it is possible to enter after restarted.
2. Functions of BootLoader program
Press the Prompt key to enter the corresponding function
a. Setting system
1. Setting time
The controller integrates real-time clock. You can calibrate the date and time with this function. Please
note that the time contains two digits. Please add 0 if there are not two digits.
2. Start interface
To avoid entering BootLoader program by mistake, you can set two start modes: one is test mode, in
which the password isn’t required; the other one is normal mode, in which the password (default: 26722719)
is required. In addition, the interface displayed when the controller is started is also different.
b. Setting BIOS
1. Updating BIOS
This function is used to update BootLoader program and won’t be used in common conditions.
2. Updating program
This function is used to write the program into ROM. Please refer to the start mode below for specific
function.
c. USB function
1. Connecting USB disk
After performing this function, if the USB cable is connected, PC will find a USB disk. In
WINDOWS2000 or WINDOWS XP system, it is not necessary to install drivers. For WINDOWS98
system, please install the provided universal USB drivers. After connecting properly, the USB indicator on
the panel should be lighted.
When the file exchange completes, in WINDOWS2000 or WINDOWS XP system, please eject the
USB disk and press the “ESC” key to exit; in WINDOWS98 system, please check the prompt on the
controller, make sure that it is in “Idle” state for at least one second and then press the “ESC” key to exit, or
else the file system may be damaged.
2. Formatting USB disk
This function clears all the data in USB disk and creates two folders (ADT and PRG). If you need to
save certain files, please copy those to PC and copy back to USB disk after formatting.
d. System self test
Not developed yet
e. Start mode
This program supports USB start and normal start. The serial port start isn’t supported because the
speed is too low.
In normal start mode, the BootLoader program copies the applications in 0x000b0000 address in ROM
to 0x0c008000 address in RAM.
In USB start mode, the BootLoader program copies the ADTROM.BIN file in ADT folder in the USB
disk to the 0x0c008000 address in RAM.
In USB start mode, you can test the program conveniently. Please copy the generated ADTROM.BIN
file to the ADT folder through USB disk, and restart the controller to perform the program.
For the tested program, please start in normal mode, because the program can’t be started if the file
system is damaged in USB mode.
The above mentioned update program writes the ADTROM.BIN file in ADT folder into ROM so as to
start in normal mode.