User manual
ADT-TP3340DJ Three-axis Dispenser
- 18 -
3) Other functions
a. Go to point: Go to specified point and edit.
b. Batch edit:
Edit the parameters in multi lines in the mode such as “Specify value”, “Scale” or
“Specify offset”. By specifying value, the specified value will be set to the specified data
field of specified data section, while the content of specified data field of specified data
section is multiplied by a specified fraction by scaling mode (note: the denominator can’t be
0). If the selected data field isn’t “Output” or “Single point time”, you can also edit the data
in batch by specifying the offset. Select the “Specify value” option and then press the
“Specify value” button to switch to “Specify offset”.
Press the “Specify value” button again to switch to “Specify offset”, as shown below:
c. Batch delete: Delete the processing points in specified range in batch.
d. Automatic round: Replace the corners of the graph with arcs to make the track smoother.
Go to line
Start point setting
Batch edit
Batch delete
Automatic round
Common graphs
Insert/ Instruction/ Delete/ Save/ Cancel
Type: X coordinates
Start point
Linear
Forward circle
End point
Start point
Line:0001/0024
Up Down
Batch edit data range: From 0001 to 0024 line
Data field to be edited:
X coordinates Y coordinates Z coordinates Speed
Single point time Needle height
Editing mode:
Specify value 0.0000 Instruction
Scale
OK Cancel
Batch edit data range: From to line
Data field to be edited:
X coordinates Y coordinates Z coordinates Speed
Single point time Needle height
Editing mode:
Specify value Instruction
Scale
OK Cancel