User manual

ADT-TP3340DJ Three-axis Dispenser
- 11 -
6) Gun offset setting
When processing with multiple glue guns, please set the offset between glue guns so as to
make the glue gun process in appropriate track. Generally, you can specify the offset of certain
glue gun to 0, and the offsets of other glue guns are relative to this glue gun.
7) Quick start file setting
To call out certain processing file quickly, you can use the quick start file. Press an external
button to open the specified quick start file and process it. Six quick start file interfaces are
available. Each quick start file corresponds to a fixed external port. Please check the wiring
diagram.
Glue gun/pen correspondence settings
First gun
Corresponding pen
Second gun
Corresponding pen
Third gun
Corresponding pen
Fourth gun
Corresponding pen
Fifth gun
Corresponding pen
Sixth gun
Corresponding pen
Fourth gun
Corresponding pen
Eighth gun
Corresponding pen
OK
Cancel
Gun offset settings
Instruction
Reference point Next OK Back
X-axis Z-axis
Instruction
Instruction
First gun
Second gun
Third gun
Fourth gun
Gun offset settings
Instruction
Reference point Next OK Back
X-axis Y-axis Z-axis
Instruction
Instruction
First gun
Second gun
Third gun
Fourth gun
Instruction
Instruction
Page: 01/01